Integral INSSD64GP18MXZ Datenblatt

10 negated at the time tA after the activation of DIOR- or DIOW-, then tRD shall be met and t5 is not applicable. 4. Mode may be selected at the

11 3.3.2 Multiword DMA Data Transfer (Initialing a Multiword DMA data burst) (Sustaining a Multiword DMA data burst)

12 (Device terminating a Multiword DMA data burst) (Host terminating a Multiword DMA data burst)

13 Multiword DMA timing parameters Mode 0 ns Mode 1 ns Mode2 ns Note t0 Cycle time (min) 480 150 1

14 3.3.3 Ultra DMA Data Transfer Ultra DMA data burst timing requirements

15 Ultra DMA data burst timing descriptions

16 (Initialing an Ultra DMA data-in burst) (Sustained Ultra DMA data-in burst)

17 (Device terminating an Ultra DMA data-in burst) (Host terminating an Ultra DMA data-in burst)

18 (Initialing an Ultra DMA data-out data burst) (Sustained Ultra DMA data-out burst)

19 (Host terminating an Ultra DMA data-out burst) (Device terminating an Ultra DMA data-out burst)

2 Features:  Standard 40-pin 1.8” form factor  Standard ATA/IDE Bus Interface - 512 Bytes / Sector - ATA command set compatible 

20 3.4 Power Management System Power Consumption: (Ta = 0 to 700C) Symbol Parameter Conditions MIN TYP MAX Unit Iccr

21 4.2 Command Sets Below table summarizes the PATA 1.8” SSD command set with the paragraphs that follow describing the individual commands and tas

22 4.3 Identify Drive Information The Identity Drive Command enables Host to receive parameter information from the device. The parameter words in

23 Word 58= MSW) 59 0101h 2 Multiple sector setting is valid 60-61 xxxxh 4 Total number of sectors addressable in LBA Mode 62 0000h 2 Retired 63 000

24 5.0 Physical Dimension 5.1 1.8” PATA SSD (Top view) (Bottom view) Unit: mm

3 TABLE OF CONTENTS 1.0 BLOCK DIAGRAM ...

4 1.0 Block Diagram 1.1 Capacity Specification Density Total Bytes Total LBA Cylinders Heads Sectors 32GB 31,272,321,024 61,078,752 16383 16 63

5 25 -DIOR 26 Ground 27 IORDY 28 Ground 29 DMACK- 30 INTRQ 31 DA1 32 PDIAG- 33 DA0 34 DA2 35 CS0- 36 CS1- 37 DASP- 38 3.3V 39 3.3V 40 Reserved 2.2

6 30 INTRQ(Interrupt) O When this device is selected, this signal is the active high Interrupt Request to the host Pin No. Signal I/O Descriptio

7 3.0 Electrical Characteristics 3.1 Absolute Maximum Rating Item Symbol Parameter MIN MAX Unit 1 VDD-VSS DC Power Supply -0.3 +5.5 V 2 VIN In

8 3.3 AC Characteristics 3.3.1 PIO Data Transfer

9 PIO timing parameters Mode 0 ns Mode 1 ns Mode2 ns Mode 3 ns Mode 4 ns Note t0 Cycle time (min) 600 383 240 180 120 1,4 t1 Add